Yamaha DEQ5 - Manual (Page 49)

Assigning DEQ5E to “CONTROL SELECT” dial of the main unit
[Example] Assigning the above DEQ5E to dial number “1”
© Press “UTILITY” key on the main unit several times to recall “REMOTE ASSIGN” menu.
l.i)
(C-l
1
20
@ Turn the rotary encoder “1” to set “CTL.SEL” to “1”.
@ Use rotary encoders “2” and “3” to set the address (GROUP:l, DEVICE:!) which were set in the procedures 5
and 6.
l.i I
©
lAI
OTL.SEL
® To assign another DEQ5(E) to “CONTROL SELECT” dial, repeat the procedures ® to ®. (To assign
additional DEQ5(E), assign the additional one to the dial number which has not been used.)
When setting in the procedure ® and ® with an additional DEQ5(E), use another address (combination of
GROUP No. and DEVICE No.) so that the address is not the same as the address which is used by the other
DEQ5(E) and already assigned to the “CONTROL SELECT” dial. [Refer to “5. Multiple DEQ5(E) remote
control (see page 46)]
® After the above setting, only selecting a certain “CONTROL SELECT” dial number enables remote operation
of DEQ5(E) which was assigned beforehand.
43