Parameter copy – Yamaha DEQ5 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Parameter copy
This menu is provided for copying parameters. The following two main copying methods can be used.
I: To copy initial data of GEQ or PEQ written in the initial data area to Edit area.
When all of the 40-program user memory is only GEQ (or PEQ), the initial data of another equalizer mode can
be recalled using the above method “I”.
II: To copy Lch or Rch parameter set value of the program in the edit area to the other channel.
‘ITEM” should be set only when “L-DATA” or “R-DATA” is selected in “FROM” in the menu.
Copying procedure
© Select data (either “GEQ-INT”, “PEQ-INT”, “LCH-PRM”, or “RCH-PRM”) to be copied by using rotary
encoder“1”.
“TO” in the menu is set to the following in accordance with the setting of “FROM”.
• When “GEQ-INT” or “PEQ-INT” is selected........................ “EDIT AREA”
• When “L-DATA” is selected.................................................... “R-DATA”
• When “R-DATA” is selected ...................................................“L-DATA”
@ (When either “L-DATA” or “R-DATA” is selected in ©) Select parameter type (ITEM) to be copied by using
rotary encoder “2”.
ALL............................................... Copies all the parameter values.
EQ....................................................Copies the parameter values set in the Equalizing menu.
FILTER.......................................... Copies the parameter values set in the Filter menu.
HUM CAN......................................Copies the parameter values set in the Hum Filter menu.
DELAY/POL.................................. Copies the parameter values set in the Delay/Polarity menu.
ATT.................................................Copies the parameter values set in the Attenuator menu.
© Press “STORE/ENTER” key once. Confirmation message “COPY OK ?” is displayed at this point in the lower
center of the display.
© Press “STORE/ENTER” key again to execute copying. “EXECUTING” is displayed and copying is
confirmed.
If you want to cancel at stage press the “PRAM” key.
31