Ííii. .kiifnil, I.iil ñ, Líiií iilu vilii – Yamaha DEQ5 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
0 Select a type of data to be transmitted from the following in the section “ITEM” on the menu.
Use rotary encoder “2” to make a selection.
• ALL .............................................. This setting transmits all the internal information of the unit.
• SYSTEM ...................................... This setting transmits system setting information such as utility settings.
• MEMORY ............................ ....... This setting transmits the data stored in memory.
Only the memory number you choose can be selected and transmitted. (Refer
to procedure 5.)
• BANK............................................ This setting transmits the data inside the bank set in the “MIDI CONTROL”
menu.
Only the bank you choose can be selected and transmitted in the same way as
MEMORY. (Refer to procedure 5.)
• ASSIGN........................ .......... . This setting transmits the data set in the “REMOTE ASSIGN” menu.
• EVENT.......................................... This setting transmits the data set in the “TIME CODE EVENT” menu.
® When “MEMORY” or “BANK” is selected, memory number (or bank name for BANK) should be specified
by using the rotary encoder “3”.
Selecting “ALL” enables transmitting data of all the memories or banks together.
® After deciding the data content to be transmitted with the unit, start the bulk recording on the receiving side.
When receiving with DEQ5(E), no operation is required for receiving.
@ After starting the receiving side, start the data transmission by pressing “STORE/ENTER” key on the unit.
A
1 STORE
RECAU
V
/¿anER
MEMORY
The following message is displayed during the transmission.
Message during data transmission ([Example] When “ALL” is set in the item “ITEM”)
1 BULK DUMP- 1
н::ъ
C'UT
M I D I
HLL
ITEM
NC<
* *
HLL
Message during data transmission
When DEQ5 is receiving bulk data, the following message is displayed.
Message during data reception
When received with MIDI
jPGHl
MIDI BULK
*
®(E1
S0*1E
!§H] + 11.0 o
-IE
i.iilñ
11
,-LÍiií
iilu
vilii"
20 too
-l.OH
When received with RS-485
iF-GMiMciiaM lillTI
— I II ||i^ III I nil M i l l I
©0 so‘IS
-IE
M i
ííii.
.kiifnil
_
T
T
ot
20 too
-Lfiil
■ lOK.
27