Dynon Avionics SkyView Pilots Users Guide User Manual
Page 222

Messages and Alerts
12-6
SkyView Pilot’s User Guide - Revision S
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Engine Monitor”
name> FAULT VP-X channel fault “Warning” DEMO MODE System is in Dynon demo mode and is not airworthy “Warning” PITCH SERVO OFFLINE The Pitch Autopilot servo has SkyView. Will be seen if Autopilot servos are not receiving power. “Warning” ROLL SERVO OFFLINE The Roll Autopilot servo has stopped communicating with SkyView. Will be seen if Autopilot servos are not receiving power. “Warning” ARINC-429 OFFLINE The SV-ARINC-429 module is not communicating with SkyView. “Warning” BACKUP BATTERY LOW The backup battery connected to this display is low. “Warning” SKYNET POWER FAULT A fault has been detected in the wires that provide power to SkyView Network devices. “Warning” AUDIO SUBSYSTEM FAIL SkyView has detected a problem with the audio system. “Check Canopy Latch” Check Canopy Latch A canopy latch alert is configured; The canopy is not latched; and the engine has been advanced past a configured RPM. “Caution” STANDBY NETWORK ERROR SkyView Network has lost its secondary standby network redundancy. See below for more information. “Caution” POSITION SOURCE or GPS X FAIL Position source (GPS) failure “Caution” TRANSPONDER FAIL Transponder failure. “Caution” XPNDR HEX CODE NOT SET A SkyView Transponder or ADS-B receiver is installed but the HEX Code has not been set. “Caution” EMS SFG FILE MISMATCH The Engine sensor indications may be incorrect and screens may disagree.
stopped communicating with