Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 153)

Connex CS Admin Guide Installing a Replacement Hard Drive 147
Connex server hardware HDD replacement
As the server is configured with RAID drives which are hot swappable, the process is
fairly easy. Follow these steps to install a replacement HDD.
1. Identify the drive to be replaced. The HDD0 drive bay is at the left side, followed by
HDD1, 2, and 3.
2. Drives may be installed in any order. HDD1 may be installed before HDD0.
Remove a hard disk drive
1. Open the latch at the front of the hard drive carrier. See letter “A” in “Figure C-7:
Remove hard drive from server” .
Figure C-7: Remove hard drive from server
2. Pull out the black lever and slide the carrier from the server. See letter “B” in “Figure
C-7: Remove hard drive from server” .
3. Remove all four screws that attach the existing hard drive to the carrier, and set aside
for reuse.
4. Remove the hard drive from the carrier and place it on an anti-static surface.
If you are not installing a replacement drive immediately following, you must
replace the hard drive carrier in the server system, even if no hard drive is
installed in it for proper airflow. Note