Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 148)

142 Installing a Replacement Hard Drive Welch Allyn
6. Slide the top cover backwards about 1 inch (2.5 cm) to clear the front edge of the
chassis. Lift the top cover upwards away from the chassis. Place the cover to the side
where it will not get scratched or damaged.
Caution Use care when sliding the top cover backwards so as not to damage
the attached internal foam block, present on updated units. The foam block helps
support the video cards in place so as not to become dislodged. Do not remove
the foam block. See
“Figure C-3: Foam Block Location, Mounted to Inside of Top
Cover” on page 143 for an example of the location of this foam block.
Figure C-2: Slide Top Cover Towards Rear of CPU