Dell Brocade Adapters - Manual (Page 149)

Brocade Adapters Troubleshooting Guide 125
53-1002145-01
Adapter driver event messages
A
Authentication unsuccessful for base
port: WWN = [base port WWN or
MAC]. Error Network and
storage driver 2 (Port) Failure Authentication
failure. Mismatch of
FC-SP
configuration
between switch
and HBA. Also,
check the
authentication
secret setting.
Base port enabled: Hardware
Address = [base port WWN or MAC]. Information Network and
storage driver 2 (Port) Enabled Base port enabled
by user command. No action
required.
Base port disabled: Hardware
Address = [base port WWN or MAC]. Warning Network and
storage driver 2 (Port) Disabled Base port disabled
by user command. No action
required.
Base port online: WWN = [Base Port
WWN]. Information Network and
storage driver 2 (Port) Online Base port logged
into fabric. No action
required.
Base port offline: WWN = [Base Port
WWN]. Warning Network and
storage driver 2 (Port) Offline Base port logged
out of fabric. No action
required.
Base port (WWN = [base port WWN
or MAC]) lost fabric connectivity. Error Network and
storage driver 2 (Port) Logout Base port lost
connection with
fabric. Check switch and
HBA
configuration.
Also, check SFP
and cable
connection
stand-up
adapters.
Heart Beat of IOC [IOC instance
number] is good. Information Network and
storage driver 9 (TOC) Restart Successful restart
of firmware after a
failure. No action
required.
Heart Beat of IOC [IOC instance
number] has failed. Critical Network and
storage driver 9 (TOC) Crash Firmware not
responding. Collect all error
information and
restart the
firmware. Invoke
bfa_supportsave.
IOC [IOC instance number] is
enabled. Information Network and
storage driver 9 (TOC) Enabled Adapter firmware
started by user
command. No action
required.
IOC [IOC instance number] is
disabled. Warning Network and
storage driver 9 (TOC) Disabled Adapter firmware
stopped by user
command. No action
required.
New adapter found: SN = [adapter
serial number] base port WWN =
[Base port WWN]. Information Network and
storage driver 1
(Adapter) Added Adapter added to
host. No action
required.
New SFP found: port [base port
number], Hardware Address = [Base
port WWN or MAC].. Information Network and
storage driver
(stand-up
adapters only)
2 (Port) Found User plugged in an
SFP. No action
required.
QOS negotiation failed for base port:
WWN = base port WWN or MAC]. Warning Network and
storage driver 2 (Port) Failure QoS negotiation
failed. Check switch and
HBA
configuration.
TABLE 13 Driver event messages (continued)
Message Severity Event Type Category Sub
Category Cause Action