Dell Brocade Adapters - Manual (Page 162)

138 Brocade Adapters Troubleshooting Guide
53-1002145-01
HCM and Installer Message Reference
B
Disk space calculation
Available space is . Please free up at
least 50 MB in /opt and re-attempt the installation.
Occurs when the available
space in /opt is less than
50MB. Free at least 50MB in
/opt, and then try
installation.
Do you want to back up the HCM configurations?
Configurations are stored in data directory.
Cancel>
Occurs when you remove
the application. If you want to back up the
data, click on “Backup” or
else click “Don’t backup.”
File backup
Successfully backed up
in /boot.
Occurs when Initrd file is
backedup successfully in
/boot. No action required.
File backup
There is a back up file
already available in /boot. Do you want to overwrite?
Occurs when a backup file
named
name> is already
available in /boot When user wish to
overwrite the existing
backup file press “Yes”
else “No”
Found Backed up data.
Backed up configuration directory of HCM
dated is
found at .
Do you want to restore old configurations?
Occurs during the course
of installation when a
backup data is already
present in the system. If the user wishes to
restore the backed-up
data, the user can give
“Yes” else “No”
No matching binary rpm found
Do you want to install noarch rpm?
Note:
- noarch rpm is not recommended for RHEL/SLES.
- noarch rpm requires kernel devel/source rpm and
GCC. Occurs when a matching
binary rpm is not found. Click Yes to proceed with
the installation using the
noarch rpm or click No to
stop installation.
Path is not Valid.
You have entered an invalid backup output directory.
Please make sure the directory path is correct.
Occurs if provide an
invalid path name or
leave the path field blank. Enter a valid path to
backup the files.
Pre-Installation Message
It is strongly recommended that you quit all HCM
application running on this machine before continuing
with the Upgrade/Reinstall. Occurs after the
upgrade/reinstall
message. Stop HCM from running
before upgrading or
reinstalling the software.
Pre-requisite check is done… Occurs when driver's
pre-requisite check is
completed. Information message.
Pre-Uninstallation Message
It is strongly recommended that you quit all HCM
application running on this machine before continuing
with the Upgrade/Reinstall.
Occurs during removing
the HCM application. Close HCM or the installer
will close it before
proceeding with software
removal.
TABLE 15 Brocade Adapter Software Installer messages (continued)
Message Cause Corrective Action or Notes