Dell Brocade Adapters - Manual (Page 164)

140 Brocade Adapters Troubleshooting Guide
53-1002145-01
HCM and Installer Message Reference
B
System dependencies not available.
GCC and Kernel rpms are required for installing Storage
and Network Driver and HCM and Storage and Network
Driver.
Variable "allow_unsupported_modules" in
/etc/modprobe.d/unsupported-modules file is set to
“0”, please change it to “1” before continuing
installation otherwise the driver module will not be
loaded.
Occurs when you install
drivers on a Linux system
that does not contain the
GCC and kernel rpm and
when the variable
"allow_unsupported_mod
ules" in
/etc/modprobe.d/unsupp
orted-modules file is set
to “0” Change the “0” in variable
"allow_unsupported_mod
ules" present in
/etc/modprobe.d/unsupp
orted-modules file to “1.”
Load the GCC and Kernel
rpms on the system, and
install the drivers.
System dependencies not available.
GCC and Kernel rpms are required for installing Storage
and Network Driver and HCM and Storage and Network
Driver.
Occurs when you install
drivers on Linux systems
that do not contain the
GCC and Kernel rpm. Load the GCC and kernel
rpms on the system and
then install the drivers.
The following component(s) exist in your system.
Product :
HCM/ configuration preference
- option 1 -> Install with existing configuration
- option 2 -> Install with default configuration
Occurs when you try to
overwrite currently
installed software with a
newer version. Select whether you want
to install software using
the default configuration
or the configuration that
exists for the currently
installed software.
The following component(s) exist in your system.
Product :
Occurs when a driver was
installed using native
installer scripts or system
commands and you are
trying to overwrite with a
newer driver. Continue installing new
components or exit the
installation.
Unable to start the driver update. Occurs when driver
update not able to start. Information message.
VLAN ID cannot be empty. Enter a valid VLAN ID. Occurs when the user add
a new VLAN without
providing a VLAN ID in the
VLAN Configuration dialog
box. Provide a valid VLAN ID
while creating VLAN.
Warning message
If booting over Brocade HBA, you must have a version of
driver installed before you restart the system.
Occurs on Linux systems
during removal of driver
or HCM and driver. If booting a Brocade HBA,
make sure driver is
installed in the system
before rebooting.
Would you like to overwrite the existing driver?
The adapters on the system have a better driver version
than the one you are trying to install.
Click OK to continue.
Occurs when the system
has a better driver version
than the one you are
installing. If you want to overwrite
the existing driver, click
OK to continue.
TABLE 15 Brocade Adapter Software Installer messages (continued)
Message Cause Corrective Action or Notes