Dell Brocade Adapters User Manual
Page 160
136
Brocade Adapters Troubleshooting Guide
53-1002145-01
HCM and Installer Message Reference
B
Uploading the driver file
to the agent {0}
Occurs when HCM GUI uploads the driver file to
the agent.
Information message.
Uploading the driver file
is successful.
Occurs when driver file uploaded successfully
to the Agent host.
Information message.
VLAN and Team
configurations
successfully restored.
Occurs when the VLAN and Team
configurations are successfully restored in
HCM.
Information message.
WWN or MAC
Occurs when the user adds a invalid WWN (for
example, 00:00:00:00:00:00:00:00) or invalid
MAC address (for example,
00:00:00:00:00:00) in the Detached
WWN/MAC field or Configure Names dialog
box.
Add a valid WWN or MAC address in
the Detached WWN/MAC field or
Configure Names dialog box.
Provide a valid MAC address in the
Detached WWN/MAC field.
You are going to stop the
pending test(s) only.
All Started test(s) will
continue to run. Are you
sure you want to
continue?
This occurs when the user stops a diagnostics
test before it finishes.
Information message.
You are about to delete a
large number of virtual
port(s). Are you sure you
want to continue?
Occurs when user deletes virtual ports the
Virtual Port Deletion dialog box were
configured using HCM and BCU.
Information message.
You are about to delete
all the test logs. Are you
sure you want to
continue?
Occurs when the user selects a test log and
selects option to clear the log.
Warning. This clears all the test logs.
You are about to disable
the Port
will disable all the
devices on this Port. Are
you sure you want to
continue?
Occurs when port is disabled from the right-
click drop down menu for the port and in the
Basic Port Configuration dialog box.
Warning that disabling the port will
disable all the devices on the port.
Confirm that you wish to do this.
You are about to send
the information to the
agent. Do you want to
proceed?
Occurs when the user performs actions in the
Configure Names dialog box and selects OK or
Apply.
Either select Yes to save all
configurations or No to discard
configurations.
You are about to update
boot image to all
Adapters. Are you sure
you want to continue?
Occurs when the user clicks OK to update the
boot code image for all installed adapters.
Information message.
You did not select any
virtual port. Select one or
more virtual ports.
Occurs when the user selects Apply on the
Virtual Port Deletion dialog box without
selecting any virtual ports.
Select the desired virtual ports, then
select Apply.
TABLE 14
Host Connectivity Manager messages (continued)
Message
Cause
Corrective Action or Notes