Dell POWERVAULT MD3600F - Manual (Page 253)

Management: Installing Array Components 253
3 Connect all the cables to the RAID controller module. If SFP transceivers
and fiber optic cables were present, reinstall them in the correct ports.
4 If applicable, update the firmware for the RAID controller module. For
information about the latest firmware, see dell.com/support.
Opening the RAID Controller Module
CAUTION: Many repairs may only be done by a certified service technician. You must
only perform troubleshooting and simple repairs as authorized in your product
documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty.
Read and follow the safety instructions that came with the product.
1 Turn off the array and host server.
2 Disconnect all the power cables connected to the array.
3 Remove the RAID controller module. See "Removing a RAID Controller
Module Blank" on page 249.
4 Remove the screws from the sides of the RAID controller module. See
Figure 16-9.
5 While pressing the indent, slide the cover in the direction of the arrow and
lift it away from the RAID controller module. See Figure 16-9.
book.book Page 253 Tuesday, June 18, 2013 3:03 PM