Dell POWERVAULT MD3600F - Manual (Page 211)

Configuration: Premium Feature— Remote Replication 211
Resuming a Remote Replication
1 In the AMW of the storage array with the primary virtual disk, select the
Logical tab.
2 In the Logical pane, right-click the primary virtual disk of the replicated
pair, then select Resume Replication.
The Resume Replicated Pair dialog is displayed. The Replicated pairs table
shows all suspended replicated pairs in the local and remote storage arrays.
3 Select one or more replicated pairs. To select all replicated pairs, click
Select All.
4 Click Resume.
The Resume Replication Pair - Confirmation message is
displayed.
5 In the Confirmation text box, type Yes.
The remote virtual disk replication resumes.
The Properties panes in the AMW for the local storage array and the remote
storage array show the Replication status as Synchronized for both the
primary and secondary virtual disks.
About Resumed Remote Replications
When a remote virtual disk replication is suspended, data continues to write
to the primary virtual disk, but is not replicated to the secondary virtual disk.
Writes to the primary virtual disk are persistently logged to the replication
repository virtual disks.
After communications are restored, data transfer between the primary virtual
disk and the secondary virtual disk must be resynchronized.
Depending on which resynchronization method you specify, the following occurs:
• Automatic resynchronization—Data transfer automatically starts
immediately after the virtual disks are resynchronized.
• Manual resynchronization—You must manually resume the remote virtual
disk replication to restart the data transfer. A suspended remote virtual disk
replication stays in a Suspended status until it is manually resumed.
book.book Page 211 Tuesday, June 18, 2013 3:03 PM