Embedded system management, Baseboard management controller configuration – Dell PowerEdge R415 User Manual
Page 76
76
Using the System Setup Program and UEFI Boot Manager
Deleting or Changing an Existing Setup Password
1 Enter the System Setup program and select System Security.
2 Highlight Setup Password, press
window. Press
The setting changes to
Not Enabled.
3 If you want to assign a new setup password, perform the steps in "Assigning
Embedded System Management
The Lifecycle Controller is an embedded utility that enables systems and
storage management tasks from an embedded environment throughout the
server’s lifecycle.
The Lifecycle Controller can be started during the boot sequence and can
function independently of the operating system.
NOTE:
Certain platform configurations may not support the full set of features
provided by Lifecycle Controller.
For more information about setting up the Lifecycle Controller, configuring
hardware and firmware, and deploying the operating system, see the Lifecycle
Controller documentation at support.dell.com/manuals.
Baseboard Management Controller Configuration
NOTE:
If an iDRAC6 Express card is installed on the system, the Baseboard
Management Controller (BMC) utility is replaced by the iDRAC6 utility.
The BMC enables configuring, monitoring, and recovering of systems
remotely. BMC provides the following features:
• Uses the system’s integrated NIC
• Enables fault logging and SNMP alerting
• Provides access to system event log and sensor status
• Allows control of system functions including power on and off
R415HOM.book Page 76 Friday, September 24, 2010 9:37 AM