Compaq Professional Workstation AP200 - Manual (Page 74)

4-10 Hardware Upgrades
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: E-CH04.DOC Last Saved On: 1/19/99 9:40 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
9. Remove the subpanel as described in the section “Removing the Bezel
Blank” and reposition it with the bezel blank in the proper orientation
for the desktop configuration.
CAUTION: Hold the subpanel straight when you pull it away
from the front bezel. Pulling the subpanel away at an angle could
damage the pins that align it within the front bezel.
Desktop Configuration
Minitower Configuration
Figure 4-6. Changing from a minitower to a desktop configuration
10. Replace the subpanel, front bezel, and the workstation access panel.
IMPORTANT: Be sure the subpanel and front bezel align properly with
alignment tabs.
11. Reconnect the power cord to the grounded AC outlet, and the network
cable, then any external devices to the system.