Compaq Professional Workstation AP200 - Manual (Page 28)

2-6 Software
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: C-CH02.DOC Last Saved On: 12/15/98 4:21 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Table 2-1
Computer Setup
Task Computer Setup Selection
View the product name, processor
type/speed/stepping, CPU serial number,
system ROM date, system board revision,
installed memory size, and asset tracking
number Select File, then select System
Information.
Set the system time and date Select File, then select Set Time and
Date.
View the currently installed drive A:
(preinstalled diskette drive) and drive B:
devices and set resources for diskette drives Select Storage, then select Diskette
Drives.
Enable/disable diskette booting and diskette
writing
NOTE: After saving changes to Removable
Media, the workstation will restart. Turn the
workstation off, then on, manually.
Select Storage, then select Removable
Media.
View information regarding IDE devices
connected to the system
NOTE: ATAPI devices (CD-ROM, tape) are
listed as ATAPI devices.
Select Storage, then select IDE Devices.
Allows you to set hard drive to Ultra-DMA
(Ultra-ATA), EDMA, or PIO mode operation. Select Storage for the IDE Drive Timing.
Enables/disables IDE drive translation Select Storage for the IDE Drive
Translation.
Specify the boot order of installed peripheral
devices (such as LS-120 drive, diskette drive,
hard drive, SCSI, or CD-ROM devices) Select Storage, then select Boot Order.
Set the energy saver mode to Advanced,
Disabled, or Minimal Select Power, then select Energy Saver.
Continued