Compaq Professional Workstation AP200 - Manual (Page 34)

2-12 Software
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: C-CH02.DOC Last Saved On: 12/15/98 4:21 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
When running TEST:
1. Select the option to view the device list. A list of the installed hardware
devices appears.
2. Verify that TEST correctly detected the devices installed. This utility
will detect all devices manufactured by Compaq; devices from other
manufacturers may not be detected.
❏ If the list is correct, select OK and go on to Step 3.
❏ If the list is incorrect, make sure that any new devices are properly
installed. If you do find an installation problem, call your Compaq
Authorized Dealer, Reseller, or Service Provider.
3. Select one of the following from the test option menu:
❏ Quick Check Diagnostics—This option runs a quick, general test
on each device with a minimal number of prompts. If errors occur,
they are displayed when the testing is complete.
❏ Automatic Diagnostics—This option runs unattended, maximum
testing of each device with minimal prompts. You can choose how
many times to run the tests, to stop on errors, or to print or file a log
of errors.
❏ Prompted Diagnostics—This option allows maximum control over
the device testing process. You can choose attended or unattended
testing, decide to stop on errors, or choose to print or file a log of
errors.
4. Follow the instructions on the screen as the diagnostic tests are run on
the devices. Record any error message numbers and have them available
when you contact your Compaq Authorized Dealer, Reseller, or Service
Provider for assistance.