Compaq Professional Workstation AP200 - Manual (Page 57)

3-22 Intelligent Manageability
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: D-CH03.DOC Last Saved On: 1/19/99 9:39 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Remote Security Management is performed in two stages:
1. System administrator uses the Remote Management Setup software on a
centralized management console to define the security parameters.
2. System administrator uses a PC LAN management product to distribute
the settings over the network to remote Compaq workstations.
For more information about the Remote Management Setup software and
enabling Remote Security Management, refer to the online Remote
Management Administrators Guide included with the Remote Management
Administration Tools, and available in the Support Software CD kit or at the
Compaq website: http://www.compaq.com.
Remote Wakeup and Remote Shutdown
Your workstation has a network card installed that supports the Compaq
Remote Wakeup and Remote Shutdown functions. These functions allow a
system administrator to power on and power off a client workstation from a
remote location, supported by PC LAN management tools.
NOTE: Third-party software tools are required to remotely distribute
software.
Remote Wakeup allows the network interface controller to continue
functioning, even when power to the workstation has been turned off.
NOTE: The workstation continues to consume a small amount of electricity
even after you turn it off. Only when you disconnect the power cord from the
electrical outlet does the workstation stop consuming electricity.
For more information on using Remote Wakeup and Remote Shutdown, refer to
the online Remote Management Administrators Guide included with the
Remote Management Administration Tools, and available in the Support
Software CD kit or at the Compaq website: http://www.compaq.com.