Compaq Professional Workstation AP200 - Manual (Page 111)

6-7
Compaq Professional Workstation AP200 Reference Guide
Writer: IM Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: G-CH06.DOC Last Saved On: 12/15/98 4:26 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Solving SCSI Problems
If you encounter SCSI device problems, refer to the common causes and
solutions listed in the following table.
Table 6-3
Solving SCSI Problems
Problem Cause Solution
System with IDE and SCSI
drives will not boot from
SCSI hard drive.
The IDE drive is not disabled
through the Configuration
utility.
Compaq does not support
mixing IDE Ultra ATA and
SCSI hard drives in the same
system.
Under the Computer Setup
Advanced menu, disable
the primary IDE controller.
System will not boot from
a SCSI drive.
The SCSI drive is not
configured correctly.
Verify that drive cabling
and jumpers are set
correctly. To boot a SCSI
drive, the drive ID number
must be set to 0.