Banner EZ-SCREEN Low-Profile Safety Light Curtain Systems - Manual (Page 47)

P/N 13348 E 45
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Overview
P/N 140044 rev. E 45
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
EZ-SCREEN LP
Instruction Manual System Operation
Figure 4-5. Receiver status indicator operation (latch output configured)
Operating
Mode
Reset
Indicator
Status Indicator Zone Indicators* 7-Segment Diagnostic Display
OSSD
Outputs
Power-up OFF Single-Flash Red All Single-Flash Red
Scan code flash
3x – sequentially
OFF
Alignment Mode –
Beam 1 Blocked
OFF Red
Zone 1 Red*
Others OFF
OFF
Alignment Mode –
Beam 1 Clear
OFF Red Red or Green Total number of blocked beams OFF
Alignment Mode –
All Beams Clear Double-
Flash
Red All ON Green OFF OFF
Run Mode –
Clear
ON
ON Green or
Flashing Green
†
All ON Green ON
Latched – Blocked
Beam 1 Blocked
ON Red Red or Green* OFF
Latched – Blocked
Beam 1 Clear
ON Red Red or Green* Total number of blocked beams OFF
Latched – Clear Flashing Red All ON Green OFF
Lockout OFF Flashing Red OFF
Displays error code
(see Section 5.1)
OFF
* NOTE: If beam 1 is blocked, Zone indicators 2-8 will be OFF, because beam 1 provides the synchronization signal for all the beams.
† Flashing if Reduced Resolution is enabled.
or