Performing exploratory measurements – Metrohm 757 VA Computrace User Manual
Page 69
4.2 Exploratory specification window
757 VA Computrace – Software
59
Performing exploratory measurements
Measurements in the exploratory mode can be performed using
the following icons (in the
MAIN WINDOW
) or buttons (in the
EX-
PLORATORY SPECIFICATION
window):
Start measurement
The operation sequence (see section 3.4) de-
fined in the
EXPLORATORY SPECIFICATION
win-
dow is started. Each step of the operation se-
quence is listed in the first line of the status win-
dow beside the
button.
For the running voltage sweep there is a live dis-
play in the
EXPLORATORY CURVES
window with
automatic scaling of the axes. Manual rescaling
can be done by pressing the
The red light at the left side of the
button
indicates a current overload. In this case, stop
the measurement and change the measurement
parameters.
In the second line of the status window com-
ments or error messages concerning the running
measurement are displayed.
A running measurement can be stopped, inter-
rupted and continued. Each step in the operation
sequence can be abbreviated by clicking the
button.
Stop measurement
Stop running measurement immediately.
Hold measurement
Interrupt running measurement.
Continue measurement
Continue an interrupted measurement.
Next step
Go to next step in operation sequence.