Metrohm 784 KFP Titrino - Manual (Page 63)

3.2 Remote control commands
784 KFP Titrino
60
&Info
Object Description Input range Reference
& Root
:
à Info Current data
: Ã
.Report Transmission of formatted reports $G 3.2.2.60.
³ Ã .Select Report type configuration, parameters,
³ smpl data, statistics, silo,
³ C-fmla, def, user method,
³ full, short, mplist, curve,
³ scalc full, scalc srt, calc,
³ all, ff ditto
³
à .Checksums Checksums $G 3.2.2.61.
³ Ã .MPList Checksum of meas.point list read only ditto
³ Ã .ActualMethod Checksum of current method read only ditto
³
à .DetermData Determination data $G 3.2.2.62.
³ Ã .Write Read/write for several nods ON, OFF
³ Ã .ExV Volume of Exchange/Dosing unit read only/read+write ditto
³ Ã .MPList Measuring point list
³ ³ Ã .1 Measuring point 1
³ ³ ³ Ã .Attribute Attribute read only/read+write ditto
³ ³ ³ Ã .X X coordinate read only/read+write ditto
³ ³ ³ Ã .Y Y coordinate read only/read+write ditto
³ ³ ³ Ã .Z1 Z1 coordinate read only/read+write ditto
³ ³ ³ Ã .Z2 Z2 coordinate read only/read+write ditto
³ ³ ³ for each measuring point
³
à .TitrResults Titration results
³ Ã .RS Calculated results
³ ³ Ã .1 1 st result
³ ³ ³ Ã .Value Value read only 3.2.2.63.
³ ³ Ã up to 9 results
³ Ã .EP Endpoint
³ ³ Ã .1 1 st result
³ ³ ³ Ã .V Value read only ditto
³ ³ ³ Ã .Meas Measured value read only
³ ³ ³ Ã .Mark without meaning
³ ³ Ã up to 9 EP's
³ Ã .Var Variables C4X
³ ³ Ã .C40 Start measured value read only/read+write ditto
³ ³ Ã .C41 Titration end volume read only/read+write
³ ³ Ã .C42 Titration time read only/read+write
³ ³ Ã .C43 Volume drift read only/read+write
³ ³ Ã .C44 Titration temperature read only/read+write
³ ³ Ã .C45 Start volume read only/read+write
³ ³ Ã .DTime Time for drift corr.or dosing time read only/read+write