Metrohm 781 pH/Ion Meter User Manual
Page 53
5 Configuration
780/781 pH/Ion Meter, Manual
43
An additional way of assigning report printouts to a particular instru-
ment is by using an individual instrument name under
CON-
FIG/auxiliaries/device label
(see Section 5.4). This will then be
printed out automatically in a separate line in the report header after the
instrument Id.
date & time:
ON, OFF
This setting defines whether the date and time of the report printout are
to be printed. The date and the exact time of the measurement can ad-
ditionally be printed with each successive measured value (see follow-
ing section).
method:
ON, OFF
As well as the mode name, the name of the method used can also be
printed out in the report header if required. You can define this previ-
ously by storing the method parameters used with
method name has yet been defined then the character sequence
******** will appear.
electrode id:
ON, OFF
You can include the electrode name in the report header if you have de-
fined an electrode ID for the currently valid calibration. Otherwise this
field in the report header will remain empty.
signature:
ON, OFF
Reports which contain measuring data (measuring point, addition, cali-
bration and electrode test reports) can, depending on the configuration,
have a signature line added on. In this way the result can be provided
with a signature.
line feed
form, 0,1,2,3...999
The paper feed of the printer at the end of a report can be set here.
With continuous paper printers (e.g. Custom) you can select the num-
ber of empty lines so that after the report has been printed out you can
tear off the printed paper directly at a suitable point. For single page
printers (e.g. HP DeskJet) you can enter the special value '
form
' with
the printer after each report.