Metrohm 781 pH/Ion Meter - Manual (Page 109)

7 Various functions
780/781 pH/Ion Meter, Manual
99
7.2.2 Report identification
The report identification, known here as Report Id, is an abbreviation
describing the type of report and is primarily important for the remote
control of the pH/Ion Meter via the RS232 interface. Computer pro-
grams such as Metrohm Vesuv © 3.0 for Windows TM can identify the
produced report by this identification and use it for further evaluation.
The following report Ids exist for the 780 pH Meter and 781 pH/Ion Me-
ter:
Report Id
Report name Availability
'mp measuring points 780, 781
'co configuration 780, 781
'pa parameter 780, 781
'um user methods 780, 781
'mv measured values stored 780, 781
'cr pH calibration report 780, 781
'fp full pH calibration 780, 781
'di diagnose 780, 781
'et electrode test 780
'cc conc. calibration 781
'fc full conc. calibration 781
'ca conc. addition 781
'fa full conc. addition 781
7.2.3 Measuring point report
By pressing the key in the directly measuring meas-
urement types a measuring point report will be produced. The following
examples show versions of this type of report, the various configura-
tions of which are defined under CONFIG/print meas.value (see
Section 5.2).
A typical version of a measuring point report is the output of a single
measured value. The print criterion ' immediate ' or ' Drift ' must be se-
lected.
'mp
781 pH/Ion Meter 01104 5.781.0020
date 2004-05-28 17:00:56
user C. Weber
pH pH-1 run number 1
electr.id
id1 charge 21
id2 sample A01
#1 pH = 8.182 21.2 °C (Pt1000)
2004-05-28 17:00:56
==============
MEAS/
PRINT