Metrohm 781 pH/Ion Meter - Manual (Page 51)

5 Configuration
780/781 pH/Ion Meter, Manual
41
5 Configuration
With the key you can access the configuration menu. This
contains all the instrument settings for the pH/Ion Meter. These are in-
dependent of both the mode and the method. This means that they
cannot be stored separately like the method parameters (see Sec-
tion 6). They continue to exist until they are edited or the permanent
memory containing the instrument configuration is re-initialized (see
Section 8.5).
All the settings of this menu are described in this section. English is
used as the dialog language. For each point you will find all the possi-
ble entries or the valid entry range together with the default value. This
will always be reset when the permanent memory of the pH/Ion Meter is
re-initialized. During the input you can also deliberately call up the de-
fault value with . It is shown in bold type below.
Example:
time interval 1,2,3...365...9999 d
This setting defines a time interval in days. In this example it is the time
after which the validation of the instrument is to be carried out ( >moni-
toring/validation ). You can either enter whole numbers between 1
and 9999 or call up the default value of 365 days with .
CONFIG