Metrohm 781 pH/Ion Meter - Manual (Page 106)

7.2 Reports
96
780/781 pH/Ion Meter, Manual
7.2 Reports
A pH/Ion Meter report is produced by transmitting data to a printer or
PC via the RS232 interface. In this way you can document e.g. measur-
ing results, calibration data, method parameters or the configuration of
the instrument in written form.
A requirement for a properly functioning report output is the input of the
receiving instrument (see Section 5.6) and the correct setting of the
RS232 transmission parameters (see Section 5.7).
The following reports can be automatically printed out after a meas-
urement has been made: a measuring point report is produced directly
with the key. The automatic output of calibration,
electrode test and result reports must be defined as such under meth-
od parameters.
Apart from the measuring point report, all reports can be triggered
manually at a later date by the key. A dialog appears for
the selection of the required report with the keys: user memory Report of the memory occupancy by methods and calibration data calib short Calibration report without graphical calibration function curve calib full Calibration report with graphical calibration func-tion curve config Instrument configuration report param Current method parameters report result short Measuring result report for standard or sample addition without graphical presentation (781 pH/Ion Meter only) result full Measuring result report for standard or sample addition with graphical presentation (781 pH/Ion Meter only) el.test pH electrode test report (see Section 8.6) mv memory Output of all stored measured values all Output of all existing reports During selection these reports can also be selected directly by using the key which has the corresponding function (e.g. for a calibration report). REPORT9 Pages: 1 … 104 105 106 107 108 … 177 wrong Brand wrong Model non readable This manual is related to the following products: 780 pH Meter See also other documents in the category Metrohm Measuring instruments: 780 pH/Ion Meter: Operation via RS-232 (29 pages) 773 pH/mV Simulator (18 pages) 826 pH mobile (82 pages) 867 pH Module (63 pages) 856 Conductivity Module (46 pages) 912 Conductometer (99 pages) Sitemap
user memory Report of the memory occupancy by methods and
calibration data
calib short Calibration report without graphical calibration
function curve
calib full Calibration report with graphical calibration func-
tion curve
config Instrument configuration report
param Current method parameters report
result short Measuring result report for standard or sample
addition without graphical presentation
(781 pH/Ion Meter only)
result full Measuring result report for standard or sample
addition with graphical presentation
(781 pH/Ion Meter only)
el.test pH electrode test report (see Section 8.6)
mv memory Output of all stored measured values
all Output of all existing reports
During selection these reports can also be selected directly by using
the key which has the corresponding function (e.g. for a
calibration report).
REPORT
9