Metrohm 781 pH/Ion Meter - Manual (Page 108)

7.2 Reports
98
780/781 pH/Ion Meter, Manual
7.2.1 Arrangement of a report
The first lines of a report provide a general description. This report
header is configured under CONFIG/Report (see Section 5.1):
Report Id: 'mp
Instrument Id: 781 pH/Ion Meter 01104 5.781.0020
Date, Time: date 2004-05-28 17:00:56
...
For the output of data as measuring points, results, calibration or elec-
trode test reports further information about the mode, method, sample
number and electrode Id is included:
Report Id: 'mp
Instrument Id: 781 pH/Ion Meter 01104 5.781.0020
Date / Time: date 2004-05-28 17:00:56
User: user C. Weber
Mode / Method / Run number: pH pH-1 run number 9
Electrode Id: electr.id pH electr.1
...
Signature: Visum _______________________________
Depending on the configuration, in such measuring data reports a sig-
nature line can be added to the data.
The line 'user' appears, if a user is defined by .
If you have entered an instrument name under
CONFIG/auxiliaries/
device label then this will appear in the report header as an addi-
tional line between the Instrument Id and the Date/Time line.
In measuring point and result reports the report header contains addi-
tional information about the measured sample as Id 1 and Id 2 , if
these have been defined under CONFIG/report or are requested be-
fore the measurement as a preselection (see PARAMETER/pre-
selections ).
Each report is concluded with a finishing line. For an automatically trig-
gered original report (measuring points, results, calibration or electrode
test reports) this is in the form of a double line:
==============
Each report to be triggered manually with is concluded
with a single line:
--------------