Metrohm tiamo 2.1 Manual - Manual (Page 977)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 ￭￭￭￭￭￭￭￭ 963
Command variables
The following command variables are generated in the method run by the
command MEAS Opt and can be used in formulas under the designation
'Command name.Variable designation':
Identification Description
.BP{#}.[MEA] Measured value for the break-point (1…9) in the unit
of the measured value
.BP{#}.CNT Intensity for the break-point x (1…9) in counts
.BP{#}.TEM Temperature for the break-point # (1…9) in °C
.BP{#}.TIM Time for the break-point # (1…9) in s
.BP{#}.TRN Transmission for the break-point x (1…9) in %
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.FP{#}.[MEA] Measured value for the fix endpoint # (1…9) in the unit
of the measured value
.FP{#}.CNT Intensity for the fix endpoint x (1…9) in counts
.FP{#}.TEM Temperature for the fix endpoint # (1…9) in °C
.FP{#}.TIM Time for fix endpoint # (1…9) in s
.FP{#}.TRN Transmission for the fix endpoint x (1…9) in %
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.CNT Transmission of the last measuring point of the meas-
uring point list in %
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list