Metrohm tiamo 2.1 Manual - Manual (Page 950)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
936 ￭￭￭￭￭￭￭￭ tiamo 2.1
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can be
taken over and saved from existing measuring commands (i.e. MEAS) which
can also be displayed in curves under the designation Extern 1…3 and used
in formulas as variables 'Command name.EX1…3'-
[New]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.10.2, page 858).
[Properties]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.10.2, page 858).
[Delete]
Deletes the external measured value selected in the table.
5.6.4.9 MEAS Cond
5.6.4.9.1 MEAS Cond - Overview
Dialog window: Method ▶ MEAS Cond ▶ Properties... ▶ MEAS Cond - 'Command
name'
Command for Conductivity measurements.
Devices
This command can be executed with the following devices:
Conductometer: 712, 856
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Cond are configured on the fol-
lowing 4 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.