Metrohm tiamo 2.1 Manual - Manual (Page 1423)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.1 ￭￭￭￭￭￭￭￭ 1409
Selection None | Odd | Even
Default value None
Stop bit
Number of stop bits.
Selection 1 | 2
Default value 1
Handshake
Type of data transmission protocol.
Selection None | HW | SW
Default value None
[Connect]
Establishes the connection to the balance. The dialog window Establish
connection appears (see Chapter 7.17.5, page 1411).
[Disconnect]
Disconnects the connection to the balance (only then the device can be
deleted out of the configuration).
7.17.4 Properties - GLP
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ 'Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in the
dialog window Select date (see Chapter 2.5.1, page 79).
Comment GLP test
Comment on GLP test.
Input 1000 characters
Monitoring of GLP validity
Monitoring of GLP validity
on | off (Default value: off)
If this option is switched on then the time interval for the GLP test will be
monitored.
Monitoring can only be switched on when a date has been entered in the
field GLP test date.