Metrohm tiamo 2.1 Manual - Manual (Page 831)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 ￭￭￭￭￭￭￭￭ 817
Selection off
Default value off
Titrino
Range
-20.00 ... 20.00
Selection off
Default value off
Start rate
The measured values are not entered in the measuring point list until the
dosing rate has fallen below this value. This parameter is checked 10 s after
the start at the earliest.
Titrando, 855
Range
0.01 ... 166.00 mL/min
Selection off
Default value off
Titrino
Range
0.01 ... 150.00 mL/min
Selection off
Default value off
5.6.3.8.6.6 STAT pH - Stop conditions
Tab: Method ▶ STAT pH ▶ Properties... ▶ Stop conditions
Command name
Name of the command.
Input 25 characters
Conditions for stopping the titration. If more than one stop condition is in
effect at the same time, then the criterion which is fulfilled first will stop the
titration.
Stop volume
Stops when the given volume has been added after the start of the titration
(including start conditions). The stop volume should be adapted to suit the
sample weight or the titration vessel size.
Titrando, 855
Range
0.00000 ... 9999.99 mL
Default value 100,000 mL
Selection off