Metrohm tiamo 2.1 Manual - Manual (Page 43)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.1 ￭￭￭￭￭￭￭￭ 29
Note
In the case of variables with Index {x}, the desired number 1…9 must be
entered for x (e.g. .EP{3}.ERC for the third endpoint).
If no index is specified, then the last index will be used automatically
(e.g. .EP.ERC for the last endpoint).
Identifica-
tion Description Commands
.BLV Blank value for the sensor used for
the command (only for ISE sensor)
and/or blank value calculated from
the calibration (for CAL LOOP Conc) DET U, MET U,
SET U, STAT U,
MEAS U, MEAS
Conc, CAL LOOP
Conc, DOS U
.BP{x}.CNT Intensity for the break point x (1…
9) in counts MEAS Opt
.BP{x}.DME Measured value differential for the
break point x (1…9) MET
.BP{x}.ERC ERC or first derivative for the break
point x (1…9) DET
.BP{x}.MEA Measured value for the break point
x (1...9) in the unit of the measured
value DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TEM Temperature for the break point x
(1…9) in °C DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TIM Time for the break point x (1…9) in
s DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TRN Transmission for the break point x
(1...9) in % MEAS Opt
.BP{x}.VOL Volume for the break point x (1…9)
in mL DET, MET
.BSY Command status; 1 = BUSY,
HOLD or ERROR; 0 = READY;
invalid (variable not available) =
Command has never been started All except START
and END