Metrohm tiamo 2.1 Manual - Manual (Page 968)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
954 ￭￭￭￭￭￭￭￭ tiamo 2.1
Range 0 ... 999999 s
Default value 3000 s
Measuring interval
Time interval for entering a measuring point in the measuring point list.
712
Range
0.4 ... 999999 s
Default value 2.0 s
856
Range
0.1 ... 999999 s
Default value 2.0 s
Sample solution
Selection of the sample solution from the table Sample solutions (TC
conductivity).
Selection DIN | Table entries
Default value DIN
Start temperatur
Temperature at the time of the start of the measurement.
Range -20.0 ... 150.0 °C
Default value 20.0 °C
Stop temperature
Temperature at the time of the end of the measurement.
856
Range
-20.0 ... 150.0 °C
Default value 40.0 °C
5.6.4.10.4 MEAS TC Cond - Additional measured values
Tab: Method ▶ MEAS U ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together with the measured values present in the
default settings in additional measured value columns Calculated # or
External # in the measuring point list .