Metrohm tiamo 2.1 Manual - Manual (Page 433)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 ￭￭￭￭￭￭￭￭ 419
Check at start
on | off (Default value: on)
If this option is enabled, the start test will check if the method variable is
valid and if the limit values are maintained when monitoring is switched on.
Note
Switching off this option can be useful if the method variables are still
invalid at the start of the method and will not be defined until there is a
REQUEST command during the run.
Comment
Freely selectable comment on the method variable.
Input 1000 characters
Variable monitoring
Note
Is displayed only for method variables of the types Number or Date/
Time.
on | off (Default value: off)
The limits for the variable will be monitored while the determination is run-
ning if this option is enabled.
Lower limit
Lower limit for the variable.
Type = Number
Input
10 digits
Type = Date/Time
Selection
'Date'
Upper limit
Upper limit for the variable.
Type = Number
Input
10 digits