Metrohm tiamo 2.1 Manual - Manual (Page 1443)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.1 ￭￭￭￭￭￭￭￭ 1429
Rack code
Shows the number of positions on the rack attached. If no rack is attached,
-------- is displayed.
Number of positions
Shows the number of positions on the rack attached. If no rack is attached,
-------- is displayed.
Shift rate
Shift rate for manual control of the sample changer.
Range 5 ... 20 °/s
Default value 20 °/s
Lift rate
Lift rate for manual control on the selected tower.
Range 5 ... 25 mm/s
Default value 25 mm/s
Swing rate
Swing rate for manual control of the Swing Head on the sample changer.
Range 10 ... 55 °/s
Default value 20 °/s
[Initialize rack]
The rack in position is initialized.
Note
When initializing the rack, the following actions are carried out:
– Move rack in position to read out rack code.
– Transfer rack data for the rack code to sample changer.
– Move lifts upwards to 0 mm
– Move robotic arm back.
8.4.4.3 Sample changer - Move
Program part: Manual Control
Here the moving to desired rack, lift or robotic arm position can be triggered
manually.
Rack position
Set rack position.