Rockwell Automation 2755 Decoded Hand-Held Scanner - Manual (Page 75)

Communication Setup (Cable Configuration) 4-19
Publication 2755-6.2
Setting Scanner Emulation Synapse Cable Options
The following define the communication options available when the
scanner is connected to the following scanner emulation interface cable:
•
Catalog No. 2755-HFC-SA1-01
Default Settings
Scan the SET SCANNER EMULATION CABLE DEFAULTS bar code
to set the interface cable to default settings. Refer to the table below for
the default settings.
Item Default Setting
Refer to
Description
on Page:
Programming
Guide➀
Page Reference
Emulation Standard 4-20 7-2
Leading Margin 80 Millisecond 4-20 7-3
Decode LED Enabled 4-20 7-3
Emulation Timeout 3 Seconds 4-21 7-4
Polarity Margin Low / Bar High 4-21 7-5
Unknown Characters
Send Bar Codes with
Unknown Characters
4-21 7-5
Convert All to Code 39 Disabled 4-22 7-6
Code 39 to Code 39
Full ASCII
Disabled 4-22 7-6
Parameter Set Parameter Set 1 4-23 7-7
➀ Bar Code Programming Guide for Decoded Scanners (Publication 2755-6.5).