Rockwell Automation 2755 Decoded Hand-Held Scanner - Manual (Page 71)

Communication Setup (Cable Configuration) 4-15
Publication 2755-6.2
Intercharacter Delay
Some devices require a delay between characters to simulate the effect of
keystroke delays (characters are sent at a lower rate). The default is
short delay (5 msec). The options are:
•
Short 5 msec delay (default)
•
Medium 50 msec delay
•
Long 99 msec delay
Advanced Features
The advanced feature options allow you to store communication
parameters for up to two applications. If you have already configured
the scanner, all of the communication settings are stored as Parameter 1
settings (default setting). Using the advanced feature options, you can
also create Parameter 2 settings. When using the scanner, scan the
correct parameter setting bar code to configure the scanner for each
application.
To set Parameter Set 1 configuration:
1. Configure the scanner communications as described in this chapter.
Since Parameter Set 1 is the default you do not have to scan the
Parameter Set 1 bar code.
To set Parameter Set 2 configuration:
1. Scan the PARAMETER SET 2 bar code.
2. Configure the scanner communication parameters as described in this
chapter.
To set defaults for a parameter set, scan the appropriate default bar code.
The selections are:
•
SET DEFAULTS CURRENT PARAMETER SET
•
SET DEFAULTS BOTH PARAMETER SETS