6 on_line! command: accessing online functions – Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 User Manual
Page 98

5Ć42
AutoMax Programming Executive Version 3.x
3ĆHole Punched Paper Ć This option is useful only when printing in
landscape mode. Check this box if you want to leave an extra four
lines (1/2 inch) at the top of the page for 3Ćhole punched paper.
These four lines will be included in the number of lines per page, so
there will be four fewer lines of print on each page. The default is
unchecked (not selected).
Lines Per Page Ć Select Full Page or Lines Per Page.
If you select Full Page, AutoMax will automatically print the maximum
number of lines that can be printed per page based on the
information entered on the Printers configuration screen in the
Windows Control Panel. This number will be displayed next to the
Full Page option.
If you select Lines Per Page, enter a number between 20 and one
less than the number displayed for Full Page.
5.6
On_Line! Command: Accessing Online
Functions
Select OnĆLine! to access the online functions. These functions are
described in sections 10 through 18 as follows:
D Section 10.0 Ć AutoMax Processor Overview Ć Describes the
AutoMax Processor module and online operation of the AutoMax
distributed control system.
D Section 11.0 AutoMax ON LINE Menu Ć Describes how to load,
run, stop, monitor, and modify application tasks in the rack. Also
describes Processor error logs.
D Section 12.0 Ć ON LINE Menu: Connect Ć Describes how to
change the baud rate, enter/release the password, and enable
and disable AUTO RUN of application tasks.
D Section 13.0 Ć ON LINE Menu: Info/Log Ć Describes how to display
information about the system software on any Processor or UDC
module in the rack and how to view the status and error log for
tasks.
D Section 14.0 Ć ON LINE Menu: Transfer Ć Describes procedures for
changing the default path or viewing the contents of the default
system. Also contains procedures for loading tasks onto the rack
and saving application tasks from the rack.
D Section 15.0 Ć ON LINE Menu: Running Tasks Ć Describes how to
run tasks.
D Section 16.0 Ć ON LINE Menu: Stopping Tasks Ć Describes how to
stop tasks.
D Section 17.0 Ć ON LINE Menu: Deleting Tasks Ć Describes how to
delete tasks from the rack.
D Section 18.0 Ć ON LINE Menu: Monitoring and Editing Tasks Ć
Describes how to monitor and change status of variables and I/O
points, display and modify Ladder Logic sequences in real time,
and force and unĆforce variables.
D Section 19.0 Ć ON LINE Menu: Error Clear Ć Describes how to clear
the Processor or UDC error log or errors displayed on the
Processor LEDs.
D Section 20.0 Ć Software Troubleshooting Ć Describes typical errors
that can occur and procedures for correcting these errors.