11 accessing the variable configurator – Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 User Manual
Page 112

6Ć14
AutoMax Programming Executive Version 3.x
6.10.3
Selecting a Drive (DPS systems only)
If you are configuring a Distributed Power drive system (DPS), the
GoTo menu will provide two additional options (Drive A and Drive B)
after you have zoomed into a UDC module. The Drive A and Drive B
commands can be used to select PMI A or PMI B so that you can you
can add analog or digital rails, thumbwheel switches, or LED
modules. See the DPS Configuration and Programming instruction
manual (SĆ3006, SĆ3015, or SĆ 3016) for detailed information.
6.11
Accessing the Variable Configurator
After you have configured a rack, select Configure Variables from the
Configure menu to access the Variable Configurator. Use the Variable
Configurator to assign variable names for I/O on a form designed
specifically for each module. Section 7 describes the Variable
Configurator.