Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 User Manual
Page 73
5Ć17
Using the System Configurator
Drive Ć Enter the source drive or the destination drive. If A
or B is entered, the AutoMax Executive software assumes
the drive is a floppy drive; otherwise, AutoMax assumes a
hard drive.
Library Ć Enter the library directory to copy the section(s)
from or to.
Format Floppies Ć Select if you want to format destination
diskettes.
High Capacity Ć Select if you want to format and/or write to
high density diskettes. The appropriate diskette capacity
will be displayed.
Section(s) Ć The Executive software will list the sections(s)
selected when the Transfer command was called. If you
are transferring out of the current library and system,
make certain that this field lists all of the sections you have
selected. If you are transferring sections in, enter the
section names separated by commas or spaces.
Step 4.
Select which of the following groups of files you want to
transfer with each section:
Object files Ć compiled application tasks, parameter object
files, and rack configuration object files.
CrossĆreference files
Transfer Tokens (See Appendix N for more information.)
Step 5.
Select Help for information relative to the transfer
procedure, Cancel to return to the System Configurator
without transferring a section, or OK to begin the section
transfer.
Figure 5.9 Ć Transfer Section