Rockwell Automation 2706 DL20 SERIES G USER MANUAL - Manual (Page 92)

Chapter 8
Special Functions
8–4
The next prompt is:
LOG ATTRIBUTES?
If you answer Yes, the system attribute settings, such as baud rate, parity,
port settings, autorun message, master address, and background message are
printed followed by a listing of the messages selected and their attributes.
After responding to the LOG ATTRIBUTES? prompt, there is a 15 second
delay before printing begins. This allows you to disconnect the terminal and
connect the printer.
Note: If you are using keyboards (Catalog No. 2706-NK1 or -NK2), the
printer can already be connected to the RS-232 port terminals 6, 7, and 8.
If you are using a printer with a keyboard, you do not have to wait, just press
the [Esc] key to begin printing.
An example of a message print:
message number: 3
uses all lines
line mode msg
to slave: 100
wait time: 3
chained to: 7
msg stacked
Overload Tripped On Heater
Lines are automatically formatted for the line length of your printer. Printer
line lengths are set using the Set Up I/O Ports special function described later
in this chapter.
Print Messages