Rockwell Automation 2706 DL20 SERIES G USER MANUAL - Manual (Page 129)

Appendix B
Tape Recorder Setup
B–3
5. Select desired function: WRITE TO TAPE, READ FROM TAPE or
VERIFY TAPE.
6. Follow the instructions provided by the DL20. The following is an
example of WRITE TO TAPE.
DL20 Prompt Action Required
WRITE TO TAPE? Type [Y] [Return] on the keyboard.
HIT STOP/REWIND
Press Stop/Rewind on the data recorder and wait for the tape
to rewind.
PLUG IN 1770-SB
Plug the cable (Catalog No. 2706-NC4) into the
CONTROLLER EQUIPMENT port on the data recorder.
PRESS RECORD ON TAPE Press Record on Tape button on the data recorder.
PUT TOGGLE ON RECORD
Put toggle switch on cable (Catalog No. 2706-NC4) to the
REC position.
TIME LEFT: 15
(counts down to 1, then additional 10
second delay)
Wait until timer counts down or press [Esc]. An additional 10
second pause occurs.
ADDR:
(counts up as data is output)
Wait while data is being transferred.
PUT TOGGLE ON OFF
Put toggle switch on cable (Catalog No. 2706-NC4) to the
OFF (middle) position.
HIT STOP / REWIND Press Stop/Rewind button on the data recorder.
UNPLUG 1770-SB Unplug the cable (2706-NC4) from the data recorder.
VERIFY TAPE? Answer [Y] and follow the prompts, press [N] to return to edit.