Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers User Manual
Page 92

Publication 1753-UM002A-EN-P - July 2005
10-8 Monitor Status
0001
0x080D
The target’s unique node identifier was not set.
0001
0x080E
The target’s unique node identifier does not match. The
message was likely routed to this node in error.
0001
0x080F
The configuration operation was not allowed.
0004
0005
0000
Extended status is out of memory.
0004
0005
0001
Extended status is out of instances.
000F
0203
The connection has timed out.
00FF
2001
One or more of the system address segments that a device
must interpret to direct a message to its destination object is
excessive.
00FF
2002
A parameter value is bad.
00FF
2018
Semaphore reject occurred.
00FF
201B
Size is too small.
00FF
201C
Size is invalid.
00FF
2100
Privilege failure occurred.
00FF
2102
Password is invalid.
00FF
2103
No password was issued.
00FF
2104
The address is out of range.
00FF
2106
Data is in use.
00FF
2107
Type is invalid and not supported.
00FF
2108
The controller is in the upload and download mode.
00FF
2109
An attempt was made to change the number of array
dimensions.
00FF
210A
The symbol name is invalid.
00FF
210B
The symbol does not exist.
00FF
210E
The search failed.
00FF
210F
The task cannot start.
00FF
2110
Unable to write.
00FF
2111
Unable to read.
00FF
2112
The shared routine is not editable.
00FF
2113
The controller is in fault mode.
00FF
2114
Run mode is inhibited.
General
Status
Error Code
(00gg)
Extended
Error Code
(nnnn)
Description