Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers - Manual (Page 58)

Publication 1753-UM002A-EN-P - July 2005
6-2 Create a GuardPLC Project with High-Speed Safety Protocol
If you are opening an existing project, created in a prior version
of RSLogix Guard PLUS!, the software automatically converts the
project to the new version.
2. In the Hardware Management dialog, right-click on the
controller Resource and select Properties.
3. Specify the controller type (GuardPLC 1600 or GuardPLC 1800
controllers only for HSP) and enter the System ID (SRS) of the
controller. If you do not know the SRS, you need to connect the
controller directly to your computer’s Ethernet port and use the
Communication Settings dialog to retrieve the SRS. See step 1 on
page 6-5.
TIP
Make a backup copy of your existing RSLogix
Guard PLUS! project before opening it in the
latest version, since the latest version
automatically converts the existing project.