Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 - Manual (Page 253)

C • F ACTORY T ALK D IRECTORY I NTEGRATION
243
8. Under Server or Collective Name, either select your FactoryTalk Historian ME IP
address from the dropdown menu or enter a new server name or IP address and
click [Test Server Connection].
You should receive a Server found message. If you do not receive this message
within a few minutes, the module may still be rebooting. Wait a few more
minutes, verify the server name or IP address, and try again.
9. Click [OK].
After the module is registered within the FactoryTalk Directory, its name appears
in the Historical Data ME folder. You may need to expand the folder to display
your registered module.
Creating a New User
You can view preconfigured user groups from the FactoryTalk Administration
Console. Each user group is created automatically when the FactoryTalk Historian
The write-in capability only applies if you are adding the name of a single Historian SE
server and not a server collective. For information about adding SE server collectives,
please see KnowledgeBase article 61952.