Rockwell Automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) User Manual User Manual
Page 18
Publication 1761-UM006E-EN-P - August 2005
1-6 Product Overview
Table 1.6 Ethernet Settings
Setting
Default
Other Options
Ethernet Speed/Duplex
(1)
(1) Series D only.
10 Mbps half-duplex
(series A, B)
Auto Negotiate (series C, D)
0 = Auto Negotiate
1 = 10 Mbps half-duplex
2 = 10 Mbps full-duplex
3 = 100 Mbps half-duplex
4 = 100 Mbps full-duplex
SMTP Username
null
45 character username
SMTP Password
null
45 character password
SMTP Authentication
Disabled
0 = Disabled
1 = Enabled
Configuration Security
Mask
000.000.000.000
Valid IP address
Save/Reset
(2)
(2) See page 4-19.
n/a
0 = save configuration to flash
1 = simple reset
2 = reset to out-of-box defaults
3 = reset to out-of-box, except
maintain current IP
configuration
From String
ENI192.168.1.254@eni1761.
org
(4)
(4) TThe ENI/ENIW address, 192.168.1.254 will be replaced by the IP address assigned to the ENI/ENIW. For
example, the string may be [email protected]. If the ENI/ENIW does not have an assigned IP
address, the string will be read as [email protected] for the series D or [email protected]
for series A, B, or C.
ENI/ENIW Identifier
IP Address
000.000.000.000
192.168.1.254
valid IP Address
Subnet Mask
0.0.0.0
(5)
(5) See page 4-17 for Subnet Mask auto-detect mode details.
valid subnet mask
Gateway Address
0.0.0.0
valid IP address
Security Mask 1
0.0.0.0
valid IP address
Security Mask 2
0.0.0.0
valid IP address
Email Server
000.000.000.000
valid IP address
BOOTP Configuration
0
0 = BOOTP initially
1 = BOOTP/DHCP disabled
2 = BOOTP fallback
(6)
3 = BOOTP always
(6)
4 = DHCP always
(6)
(6) Series C and higher.
Baud Rate
(3)
(3) Changes to the Baud Rate take effect when the ENI/ENIW power is cycled, or the configuration is saved to
flash.
See page 4-14.
Autobaud enabled with
autodetect of CRC/BCC
Ethernet Hardware
Address
Factory Value - Read Only
(see the nameplate on the
unit)
Factory Value