Rockwell Automation 1395 ControlNet Communication Board - Manual (Page 41)

3–27 Configuration & PLC Interfacing
Publication 1395–5.37– March, 1999
Drive System Reset This function causes the Drive to do a “warm boot restart”. Any data
in Drive memory at the time the command is issued is erased and is not
saved in EEPROM.
PLC Block Transfer Instruction Data –
Write
Size In Elements: 4
Processor Type: PLC-5
Destination Address: N40:0-3
Message Structure –
0
PLC Message Write
Header
Word 1
0
Function Code
1539
Message Length
8 bytes
Header
Word 2
Header
Word 3
Header
Word 4
Message Operation – The DRIVE SYSTEM RESET function causes
the Drive to reboot all processors. This is the same sequence that the
Drive goes through when power is first applied.
IMPORTANT: Any parameter data or configuration links that were
not stored in EEPROM prior to the Drive receiving this command will
be erased.
This function requires the message header only. The Drive will not
provide a response message to this command.