Rockwell Automation 1395 ControlNet Communication Board - Manual (Page 14)

2–4
Publication 1395–5.37 – March, 1999
DIP Switch Orientation DIP Switch orientation (Figure 2.2) on the CNA board is as Follows:
CLOSED = “ON” = “1”
OPEN= “OFF” = “0”
Figure 2.2. DIP Switch Orientation
On On Off Off
On
Off
Board Location The standard mounting position for the CNA board is Port B of the
Drive (Refer to Figure 2.3). If required, the Adapter can be mounted in
Port A. Note that each port uses different parameters to store Adapter
setup and configuration information.
Figure 2.3. CNA Board Mounted in Port B
AB0747A
J3
*
J1
*
*
ControlNet Adapter
(CNA) Board
J1
PORT A PORT B
J5