Rockwell Automation 1395 ControlNet Communication Board - Manual (Page 30)

3–16 Configuration & PLC Interfacing
Publication 1395–5.37– March, 1999
EE Memory Recall This function takes the information stored in the Drive’s EEPROM
memory and places it in Drive memory.
ATTENTION: All data that was stored in Drive memory
prior to issuing the EE RECALL command will be erased
when an EE RECALL takes place.
PLC Block Transfer Instruction Data –
Write Read
Size In Elements: 4 4
Processor Type: PLC-5 PLC-5
Destination Address: N40:0-3 N40:0-3
Message Structure –
0
PLC Message Write PLC Message Read
NOTE: Word 4 of the PLC Message Read instruction is broken down
into two bytes. The High byte contains the status bits
The Low byte contains the Drive message length in bytes.
Header
Word 1
0
Function Code
257
Message Length
8 bytes
Header
Word 2
Header
Word 3
Header
Word 4
0
Header
Word 1
0
Function Code
257
See Note
Header
Word 2
Header
Word 3
Header
Word 4
Message Operation – The EE Memory Recall function instructs the
Drive to replace the contents of Drive memory with the values that are
stored in EEPROM. Any configuration links present in the Drive will
also be replaced by those in EEPROM.
IMPORTANT: This message is ignored by the Drive when it is running
(i.e. the contactor is picked up).
This function requires the message header only. The status byte will
indicate the success or failure of the request.