Rockwell Automation 284E ArmorStart EtherNet IP Communications and Control Programming Manual - Manual (Page 68)

68 Rockwell Automation Publication 280E-PM001A-EN-P – August 2011
Appendix A ArmorStart ® EtherNet/IP ™ Communications & Control Programming Manual
Over Temperature
Indicates that the operating temperature has been exceeded. This fault cannot be
disabled.
Phase Imbalance
Indicates an imbalance supply voltage. This fault can be disabled and is disabled
by default.
Over Current
Indicates the drive has detected an over current fault. This fault cannot be
disabled.
A3 Power Loss
Power has been lost or has dropped below the 12V threshold . This fault can be
disabled and is disabled by default.
Internal Communication Fault
Indicates an internal communication fault has been detected. This fault cannot
be disabled.
DC Bus Fault
Indicates the drive has detected a DC Bus Fault. This fault cannot be disabled.
EEPROM Fault
This is a major fault, which renders the ArmorStart inoperable. This fault cannot
be disabled.
Hardware Fault
Indicates incorrect base/starter assembly. This fault cannot be disabled.
Restart Retries
This fault is generated when the drive detects that the auto retries count has been
exceeded. This fault cannot be disabled.