Rockwell Automation 284E ArmorStart EtherNet IP Communications and Control Programming Manual - Manual (Page 49)

Rockwell Automation Publication 280E-PM001A-EN-P – August 2011 49
ArmorStart ® EtherNet/IP ™ Communications & Control Programming Manual Chapter 5
unit in the General tab of the ArmorStart Bulletin 284E Properties
menu. If the name given to the unit was "ArmorStart", then all the
tags in the figure above would have "ArmorStart" as the prefix to the
tag names.
iii. The photo sensor is now set to be the input for turning on the signal
light and issuing a run forward command from the ArmorStart unit.
The ladder logic element should look like the figure below.
b. Select the RunForward tag for the output ladder element for Rung 0.
i. Double click on the question mark over the output ladder element
on Rung 0 and click on the drop-down arrow to show the available
tag options for this element.
ii. Expand the options for the AS_EIP_284:O by clicking on the plus
next to AS_EIP_284:O. Select AS_EIP_284:O.RunForward tag
name and hit Enter.